How to Use:

To use this machine, the technician must remove the paint from the affected area to be worked on, where the tip will be used with charcoal or electrode. The earth claw should be attached to the same workpiece and the paint should also be removed to close the circuit.

The voltage of the machine should be adjusted according to the thickness of the plate, but if the adjustment point enters the red indicator, there must be some extra care as it may cause damage to the vehicle’s paint. You should only use on extremely thick plates.

The process begins after the dent has been removed with PDR technique. With the Earth wire properly connected to the plate, the technician should apply the charcoal on the dented area observing the elevation (coming back to normal) of the plate. The charcoal should be applied in motion without interruptions, as it may burn the paint if you stop it at one place.

After this procedure, the elevated part must be lowered with the help of PDR technique by using a support underneath.

The procedure should be repeated until the desired finish is achieved.